Replacement stud for mechanical tools for inserts
Interchangeable stud bolts for mounting tools for self tapping inserts allow you to simply renew the outerthread that can get worn out after mounting larger quantities.
Description
The replacement studs are available in M3 up to M16.
Beware of the 3 available length versions for the M5 and the M6 because of the different lengths ithat are possible for the self tapping insert with 3 holes!
Frequently asked questions about Replacement stud for mechanical tools for inserts
How can I reduce the wear of the replacement stud?
Small thread sizes are sensitive to wear. It is always a matter of finding the right balance between working fast enough and using as few replacement studs as possible when assembling larger quantities.
The factors influencing this are the applied tightening torque, the speed of rotation, how quickly the screwing tool can stop when the correct depth or the set torque is reached, keeping the tool properly aligned when held manually, and the hardness of the base material. Adjusting these parameters to your specific application is important during start-up and should be continuously monitored after the initial setup phase.
How to replace the replacement stud or adjust the thread length of the 620 insertion tool?
Simply pull off the shaft, as it is held in place by spring-loaded detent balls. Loosen the two set screws using the inner hex so the worn replacement stud of the insertion tool can be replaced.
Pay attention to the two flattened sides: these must be positioned correctly so that the set screws clamp against them when tightening.
Also check how far the external thread protrudes afterwards to ensure it is not longer than the length of the thread insert.
